Black Box FX150A - Manual (Page 14)

15
LINESHARE PRO
To install the Lineshare Pro on a
single phone line, as shown in Figure
3-3
, follow these steps:
• Unplug the telephone cable
from the wall jack.
• Plug one end of the telephone
cable provided with the
Lineshare Pro into the LINE
port on the back of the
Lineshare Pro. Plug the other
end of the cable into the wall
jack where the phone was
connected.
• Plug the small end of the AC
power cord provided with the
Lineshare Pro into the power
input port labeled 12 VAC on
the back of the Lineshare Pro.
Plug the AC adapter into a
standard AC outlet.
The Lineshare Pro begins a self-
check eight (8) seconds after power
is applied. When the Lineshare Pro
completes its self-check, the green
ON/PORT 1 LED remains ON.
NOTE
The line must be installed for
the unit to pass the self-test
and show proper indication
of LED ON/PORT 1 LED.
LINE PORT 1 PORT 2 PORT 3 PORT 4
12V AC
Figure 3-3. The Lineshare Pro Installed for a Single-Phone-
Line/Single-Phone Arrangement.
Telephone
Wall Jack
110 Volt
Outlet