Setting the temperature, Super function, Setup mode – Bosch B24IF User Manual
Page 11
11
Setting the
temperature
The temperature can be set from
7 °F to ć9 °F (ć14 °C to ć23 °C).
We recommend a setting of 0 °F
(ć18 °C).
F
The temperature can be changed
with the + buttons (warmer) or ć
(colder). The temperature can be
adjusted in 1 °F (0.5 °C) steps.
To adjust the required temperature:
q Activate the setup mode with
the < or > buttons.
The FREEZER symbol is
displayed.
q Set the required temperature
with the + (warmer) or ć (colder)
buttons.
Super function
The Super function is used to freeze
large quantities of fresh food and
should be switched on some hours
before the fresh food is placed in the
freezer. In general, 4-6 hours is
adequate. If the maximum freezing
capacity is used, 24 hours are
required.
When the Super function is
activated, the appliance is cooled as
cold as possible to a preset
temperature set at the factory.
The function is activated by pressing
the super button.
12.
The SUPER
$
symbol and the
Super temperature are displayed.
The function is ended:
- by pressing the super button
again,
- by activating the Eco function,
- by activating the Vacation
mode,
- by activating the Sabbath mode.
i
After approx. 2 ½ days the
freezer automatically switches
back to the temperature set
before Super function.
Setup mode
There are several menus for
adjusting the appliance functions to
individual requirements. These
adjustments can be made in setup
mode.
To activate setup mode:
q Press the setup button.
The first menu (temperature unit)
is displayed.
To switch to the next menu:
q Press the < or > button.
The next menu and the current
setting (usually On/Off) are
displayed.
To select between the different
setting options within one menu:
q Press the + or ć button.
i
A modified setting is saved
when the next menu is selected
with the < or > button.
To end setup mode:
q Press the setup button.
All modified settings are saved.
i
If no button is pressed within
12 seconds, setup mode ends
automatically. All modified
settings are saved. The required
temperature is displayed again.