Bowers & Wilkins DM6 - Manual

DM6
Floor-standing loudspeaker system
Product Summary
● Early in 1972 it was decided to fill the gap in the existing range of B&W loudspeakers between
the already successful DM2A and the DM70. Initially this was a fairly straightforward commercial
requirement but as the development programme progressed its scope widened into the
development of new measuring techniques and the use of new materials.
● It culminated in the production of what is probably the first British Loudspeaker System to take
account of relative phase between the drive units and offering a transducer that has a substantially
minimum phase characteristic throughout the audio spectrum, with the resultant improvement in the
reproduction of all transient information.
Technical highlights
● The DM6 Bass unit operated in an enclosure volume between 51-60 litres providing a system
resonance below 50 Hz.
● The Midrange Unit crosses over from the Bass unit at 500 Hz and operates up to the point of
crossover by the HF unit which was estimated around 6kHz. In view of the crossover
frequencies chosen it was necessary for this unit to have a substantially linear response from
well below 100kHz to some 10kHz.
● To compliment the other two units and carry the frequency response well above 20kHz. It
was also felt desirable that unit should have really wide dispersion and that its diameter
should be as small as possible consistent with the power handling required.
B&W Loudspeakers Ltd reserves the right to amend details of the specifications without notice in line with technical developments. E & OE. All trademarks acknowledged.
www.bwspeakers.com
Drive Units
Frequency Response
Sensitivity
Nominal Impedance
1 x TW20 high frequency unit
voice coil diameter 19mm
1 x 131mm midrange unit MW150
voice coil diameter 37mm
± 3dB 50Hz to 20 kHz, 3 metres on
axis
95dB at 1 metre
8 ohms
Power Handling
Dimensions
25W – 350W
Height including stand: 931mm
Width: 410mm Depth: 380mm