Brother DCP-130C - Manual (Page 11)

Setting Up the Machine
9
6 Print quality check
1
After the cleaning cycle is finished, the LCD
shows:
Set Paper and
q
Press Start
2
Make sure paper is loaded in the paper tray.
Press Colour Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3
Check the quality of the four colour blocks on
the sheet.
(black/ yellow/ cyan/ magenta)
Improper Setup
Avoid touching the printed surface of the paper
immediately after printing, the surface may not
be completely dry and may stain your fingers.
4
The LCD shows:
Is Quality OK?
q
a Yes b No
5
Do one of the following:
„ If all lines are clear and visible, press
a
(Yes) to finish the quality check.
„ If you can see missing short lines, press
b
(No) and go to step 6.
6
The LCD asks you if the print quality is OK for
black and colour. Press a (Yes) or b (No).
Black OK?
q
a Yes b No
Color OK?
q
a Yes b No
After pressing a (Yes) or b (No) for both black
and colour, the LCD shows:
Start Cleaning?
q
a Yes b No
7
Press a (Yes), the machine will then start
cleaning the colours.
8
After cleaning is finished, press Colour Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 3.
OK Poor