Blaupunkt QUEENS MP56 7 646 583 310 - Manual (Page 51)

Changing basic settings in the settings menu
116
Changing the volume presetting
of the telephone ( PHONE)
If the device puts a phone call
through, it always starts at the
preset volume.
Press the softkey 8 (next to
"PHONE").
The "PHONE" menu item is
fl ashing. The presetting for the
telephone volume is shown on
the main line
A .
Adjust the desired volume us-
ing the volume control
5 or
the rocker switch 3 (incre-
ments 1 to 50).
During the phone call, you can
always change the volume by
means of the volume control
5 .
Changing the volume presetting
of the signal tone ( BEEP)
If a signal tone sounds, you al-
ways hear it at the preset volume.
Press the softkey 9 (next to
"BEEP").
The "BEEP" menu item is fl ash-
ing. The presetting for the sig-
nal tone is shown on the main
line
A .
Adjust the desired volume us-
ing the volume control
5 or
the rocker switch 3 (incre-
ments 0 to 6).
You hear a signal tone at the se-
lected volume.
➔
➔
➔
➔
If you do not want to hear any
signal tones, set the volume to
zero.
"BEEP OFF" appears on the main
line
A .
Changing the presetting of the
power-on volume ( ON VOL)
You can confi gure the device so
that the playback after switch-on
always starts with the volume set
here. For this purpose, the "ON
VOL" menu item must be high-
lighted.
Press the softkey < (next to
"ON VOL").
The presetting for the pow-
er-on volume is shown on the
main line
A .
Adjust the desired volume us-
ing the volume control
5 or
the rocker switch 3 (incre-
ments 1 to 50).
The "ON VOL" menu item is
highlighted.
Restoring the volume at switch-
on ( LAST VOL)
You can confi gure the device so
that the playback after switch-on
always starts with the previous-
ly selected volume. For this pur-
pose, the "LAST VOL" menu item
must be highlighted.
➔
➔
➔
02_BA_Queens_1_GB.indd Menü116 02_BA_Queens_1_GB.indd Menü116 04.09.2006 11:00:59 Uhr 04.09.2006 11:00:59 Uhr