BenQ W20000 - Manual (Page 22)

22 Using the projector
Eng
lish Entering the password recall procedure
1. Press and hold PRESET MODE on the projector or PRESET on the
remote control for 3 seconds. The projector will display a coded number
on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to decode the number. You
may be required to provide proof of purchase documentation to verify
that you are an authorized user of the projector.
Changing the password
1. Press MENU on the projector or remote control and then press / until the Advanced Setup menu is
highlighted.
2. Press / to highlight Password and press ENTER. The Password page displays.
3. Highlight Change Password and press ENTER. The Input Current Password page displays.
4. Enter the old password.
•
If the password is correct, the message 'Input New Password' displays.
• If the password is incorrect, the password error message displays lasting for three seconds, and the
message 'Input Current Password' displays for your retry. You can either press MENU to cancel the
change or try another password.
5. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected password
down here in this manual in advance or right after the password is entered so that it is available to
you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
7. You have successfully assigned a new password to the projector.
Remember to enter the new password next time the projector is started.
8. To leave the OSD menu, press MENU.
Disabling the password function
To disable password protection, go back to the Advanced Setup > Password >
Password menu. Highlight Password and select Off by pressing
/ . The
message 'Input Password' displays. Enter the current password.
• If the password is correct, the OSD menu returns to the Password
page with 'Off' shown in the row of Password. You will not have to
enter the password next time when turning on the projector.
• If the password is incorrect, the password error message displays
lasting for three seconds, and the message 'Input Password' displays
for your retry. You can either press MENU to cancel the change or try
another password.
Note that though the password function is disabled, you need to keep the old
password in hand should you ever need to re-activate the password function
by entering the old password.
Please write down the recall code, and
contact your nearest BenQ Customer
Center.
Recall code: 0 2 1 2
Recall Password
EXIT Back
Password Changed
Password
Password
Change Password
On
EXIT Back
W20000-en.book Page 22 Monday, October 22, 2007 3:35 PM