Bosch WTA 4400 US - Manual (Page 20)

20
8. Rotate the program selector
to Off".
The indicator light goes out.
9. Open the door.
10. Take the laundry out of the
dryer.
11. Clean the filter.
The filter should be cleaned
after each drying process.
Cleaning the filter reduces the
drying time and saves energy.
12. Close the door.
i If the item of clothing still
contains residual moisture after
the indicated drying time,
- restart the program and
- reduce the drying duration
depending on the degree of
residual moisture.
Adding laundry
1. Open the door.
The drying cycle is halted.
2. Add or remove laundry.
3. Close the door.
4. Select another program if
necessary using the program
selector (see the table of
programs from page 18
onwards).
5. Press the Start button.
The On indicator light
illuminates.
Programming the
timer 6.
The program can be delayed up to
19 hours later.
Set the timer as follows:
1. Select the program you require
using the program selector.
2. Press the Start in button.
0h. flashes in the display.
i The display flashes until you
press
Start or you turn the
program selector to Off".
3. Press Start in repeatedly until
the value you require is
displayed.
4. Press the Start button to save
the time and to start counting
down.
The time you have selected
counts down. The dot flashes
in the display. The time counts
down in increments of 1 hour.
The door may be opened at any
time. This does not affect the delay
selected. The display flashes. The
program continues when you close
the door and press the
Start
button.
The delay may be cleared or
changed at any time.
1. Turn program selector to Off"
(cancels the timer
programming).
2. Select the program you require
using the program selector.
3. Press the Start button and set
a new time if necessary (see
above).