Philips Flat TV - Manual (Page 9)

6
Connect your computer
EXT2
EXT1
CABLE
2
RECORDER
5 4
3
1
Other equipment (satellite receiver, decoder, DVD, games, etc.)
Connect the aerial cables 1, 2 and 3 as shown
(only if your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to
one of the euroconnectors
EXT1 or 2 to obtain a
better picture quality.
Connect the equipment which produces the RGB signals
(digital decoder, games, etc.) to
EXT1 , and the
equipment which produces the S-VHS signals (S-VHS
and Hi-8 video recorders, certain DVD drives) to
EXT2
and all other equipment to either EXT1 or EXT2.
L
R
AUDIO
OUT
Amplifier
To connect to a hi-fi system, use an audio connection
cable and connect the
L and R AUDIO outputs on the
TV set on the AUDIO IN L and R input on your hi-fi
amplifier.
AUDIO
1
R
L
2
VGA
IN
& Connect one end of a VGA cable 1 to the video card
of the computer and the other end to the
VGA IN
connector at the bottom of the TV.
Fix the connectors firmly with the screws on the plug.
é In case of a Multimedia computer, connect the audio
cable 2 to the audio outputs of your Multimedia
computer and to the
AUDIO R (right) and L (left)
inputs.
The VGA connector allows the following TV and
monitor display modes:
Press the v key on the remote control repeatedly to select EXT1 , EXT2 (S-VHS signals from the EXT2
connector) or AV according to where you connected your equipment.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
To select connected equipment
640 x 480, 60 Hz
640 x 480, 67 Hz
640 x 480, 72 Hz
640 x 480, 75 Hz
720 x 400, 70 Hz 800 x 600, 56 Hz
800 x 600, 60 Hz
800 x 600, 72 Hz
800 x 600, 75 Hz
832 x 624, 75 Hz 1024 x 768, 60 Hz
1024 x 768, 70 Hz
1024 x 768, 75 Hz