Philips Flat TV - Manual (Page 6)

3
Use of the remote control
Note: For most keys pressing a key once will activate the function. Pressing a second time will de-activate it.
Remark: in VGA mode only some keys are valid.
* Dolby’ ‘Pro Logic’ and the double-D G symbol are trademarks of
Dolby Laboratories Licensing Corporation. Manufactured under license
from Dolby Laboratories Licensing Corporation.
†®Ò‡πº
Audio and Video equipment keys.
TV / PC
Press one of these keys to
switch the television between TV
or PC mode.
SURR Surround sound
To activate/deactivate the
surround sound effect. In stereo,
this gives the impression that the
speakers are further apart. For
models equipped with Virtual
Dolby Surround, you can obtain
Dolby Surround Pro Logic*
sound quality. In mono, a stereo
spatial effect is simulated.
Note:You can make the same
selection in the Sound menu, Virtual
Dolby.
V To adjust the volume.
i On Screen information
To display/remove the
programme number, the time, the
sound mode and the time
remaining on the timer.
Hold down for 5 seconds to
permanently display the
programme number on the
screen.
Ma Smart keys
To select predefined picture and
sound settings.
Personal refers to the personal
preference settings selected in
the sound and picture menu.
VCR DVD TV SAT AMP
See ‘Audio- and Video equipment
keys’, p. 10.
v Select your peripherals
See p. 6.
b Teletext On/Mix/Off, see p. 9.
Colour keys, see Teletext.
OK Press this key to display the
programme list.
MENU Main menu on/off
¬ Interrupt the sound or restore it.
P Programme selection
To move up or down a
programme.The number and the
sound modes are displayed for a
few seconds.
For some TV programmes the title of
the programme appears at the
bottom of the screen.
0/9 Digit keys
To select a TV channel.
For a two digit programme
number, enter the second digit
before the dash disappears.To
switch immediately to a selected
one digit TV channel, keep the
digit key pressed a bit longer.
0 Previous TV channel
Press to display the previously
selected TV channel.
:g Teletext keys. See p. 9.
X Sound mode
To switch from Stereo or
Nicam Stereo to Mono, or to
choose between Dual
Y or
Dual Z in case of bilingual
transmission.
When the sound mode is Mono,
the indication is displayed in red.
h Active control on/off/on
with sensor
Optimizes the quality of the
picture according to the quality
or reception.
B Standby
Press to switch the TV on or off.
b
¬
+
-
V
+
-
P
v
i 0
VCR DVD TV SAT AMP
MENU SURR
1 2 3
4 5 6
7 8 9
0
‡ π
†
®
®
® ®
q g
:
h X
SMART SMART
a M
B
OK
SELECT
Ò ®
º
TV PC