Philips Wake-up Light - Manual (Page 9)

using the appliance
setting the alarm
When you set the alarm, you choose the light intensity level, the type of sound and the sound level.
The alarm is set when the light ring round the ALARM button is on. The light intensity slowly
increases to the chosen level during the last 30 minutes before the set alarm time. The sound slowly
increases in 90 seconds to the chosen level after the set alarm time.
setting the alarm time
1 Press the alarm time button ( *) to set the alarm. (Fig. 9)
The alarm time starts flashing and two arrows appear above and below the alarm
time (Fig. 10).
Use the % and the ^ buttons to set the alarm time, i.e. the time at which you wish to get
up. (Fig. 11)
Press the button longer to put the time forward or backward more quickly.
Press the alarm time button ( *) again to confirm the alarm time. (Fig. 9)
The arrows disappear and the alarm time stops flashing.
Note: If you do not confirm the alarm time, the flashing stops after 10 seconds. This means that the
alarm time has been set.
setting the sound and the sound level
1 Press the ALARM button (Fig. 12).
The light ring round the ALARM button goes on (Fig. 13).
The first sound symbol (radio) flashes for 3 seconds and the sound can be heard.
Press the ALARM button again if you want to select another wake-up sound. When you have
found the sound you want to use, do not press the ALARM button again (Fig. 12).
After 3 seconds, the symbol of the sound selected stops flashing to indicate that it has been
selected.
The alarm has been set and continues to work until you switch off the alarm function. When
you do this, the sound symbol disappears from the display and the light ring round the
ALARM button goes out. See also section ‘Switching the alarm on or off’.
Turn the volume control wheel $ to set the sound level. (Fig. 14)
The $ appears on the display. (Fig. 15)
If you want no sound at wake-up time, select level 0.
setting the light intensity level
1 Use the light adjustment wheel @ to set the light intensity level. (Fig. 16)
The @ appears on the display.
Tip: When you use the appliance for the first time, set the light intensity to 20. The moment you wake up,
check which light intensity level the appliance has reached by slightly turning the light adjustment wheel
@ . When you do this, the current alarm light intensity level appears on the display. Set the alarm light
intensity to this level for the next day.
If you do not want the light to go on at wake-up time, select light intensity level 0.
Quick alarm check
1 Press the QUICK CHECK button to start an accelerated wake-up alarm test (Fig. 17).
The light ring round the QUICK CHECK button goes on (Fig. 18).
,
,
,
,
,
,
,
,
,
EnglisH 9