Philips Wake-up Light - Manual (Page 12)

1 Clean the outside of the appliance with a damp cloth.
Clean the inside of the appliance with a dry cloth.
Open the lamp replacement hatch by first pushing the rib at the bottom inwards (1) and
then upwards with some force (2) (Fig. 28).
Tilt the lamp replacement hatch outwards as far as it goes (Fig. 29).
Do not let water run into the appliance or spill water onto the appliance (Fig. 3).
replacement
Except for the lamp, the appliance does not contain any serviceable parts.
The lamp has to be replaced when it stops burning or when the light output decreases (also see
chapter ‘Important’). You must replace the lamp with a Philips 100W E27 SOFTONE softwhite 230V
T55 lamp. Only this lamp provides the correct light intensity.
replacing the lamp
1 Unplug the appliance.
Let the appliance cool down for approx. 15 minutes.
To open the lamp replacement hatch, first push the rib at the bottom inwards (1) and then
slide the hatch upwards with some force (2) (Fig. 28).
Tilt the lamp replacement hatch outwards as far as it goes (Fig. 29).
5 Unscrew the old lamp (1) and remove it from the lamp holder (2) (Fig. 30).
6 Screw a new lamp in the lamp holder.
Environment
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 31).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer.
guarantee restrictions
The international guarantee does not cover the lamp.
,
,
,
-
EnglisH 1