Brother XL-6051 - Manual (Page 36)

24
KNOWING YOUR SEWING MACHINE
CONOZCA SU M
Á
QUINA DE COSER
CONOSCERE LA MACCHINA DA CUCIRE
1
3
2
1
2
3 4
· ·
4 · 3 · 2 · 1 · F · 0 .................... SS
A A A A A
Stitch Length Dial
Depending on your selected stitch, you may need to adjust the stitch
length for best results.
The numbers marked on the Stitch Length Dial represent the length
of the stitch in millimeters (mm).
THE HIGHER THE NUMBER, THE LONGER THE STITCH.
The “0” setting does not feed the material. This is used for sewing
on a button.
The “F” area is used for making a Satin Stitch (a dense zigzag stitch)
which can be used in making buttonholes and decorative stitches.
The position needed for making the Satin Stitch varies according to
the material and thread being used. To determine the exact dial
position, you should first test the stitch and length settings on a
scrap of fabric to observe the feeding of the material.
1 Stitch length dial
2 Length
3 Fine
→ SS
4 Coarse
CAUTION
Do not set the Stitch Length Dial in the range shown by A
A A A A. If
the machine is started while the dial is set in the range shown
by A
A A A A, the fabric will not feed correctly and the fabric or
machine may be damaged.
Turn the dial to the left past “0” for the SS position.
SS (Fixed 2.5)
CAUTION
If the stitches get bunched together, lengthen the stitch
length and continue sewing. Do not continue sewing with-
out lengthening the stitch length, otherwise the needle may
break and cause injury.