Philips Pronto Extensor en serie - Manual (Page 13)

ENGLISH
10
RFX9600 Starter’s Guide
2 Make sure that the PC is switched to DHCP while the Extender is in configuration
(normally, this should already be the case).
3 Set the Configuration switch to 2 for configuration:
The Extender will restart. After start-up, the Power and Ethernet LEDs are green and the Busy
LED is red/green blinking.
4 Open the browser.
5 Type the IP address of the Extender in the address bar of the browser: 192.168.8.80.
(This is also printed on the back of the Extender.)
You may have to refresh the browser before the Configuration Tool appears.
6 Make sure you have the IP address and netmask at hand, and follow the onscreen
instructions.
7 When the configuration is completed, disconnect the Extender from the computer and
reconnect it to the router with a straight Ethernet cable. Set the Configuration switch
to 1 for use.
Configuration through a router
1 The Extender is already
connected to the router.
Connect the router to the PC
as well.
2 Set the Configuration switch to 3 for configuration:
The Extender will restart. After start-up, the Power and Ethernet LEDs are green and the Busy
LED is red/green blinking.
3 Open ProntoEdit Professional on the PC.
4 In the Tools menu, select Extender Discovery.
The Extender Discovery tool appears, with a list of all the detected Extenders in the Pronto
Network.
Configuration switch: 2
Configuration switch: 3
Extender
Straight
Ethernet cable
Router
RFX9600_SG_ESFv3.qxd 07-09-2006 15:38 Pagina 13