Connecting to relay-controlled equipment, Connecting to serial equipment – Philips Pronto Extensor en serie User Manual
Page 10
7
RFX9600 Starter’s Guide
Connecting to Relay-controlled Equipment
Use standard wiring and Phoenix
connectors.
Use standard wiring and Phoenix
connectors.
Connecting to Serial Equipment
There are two ways to connect serial equipment to the Extender:
Tip
In case you experience communication problems when using the RS232 wiring solution
illustrated above, make sure that the GND pin on the Extender is grounded correctly on the side
of the AV-component.
RFX9600_SG_ESFv3.qxd 07-09-2006 15:38 Pagina 10
This manual is related to the following products: