Bosch WFMC5301UC - Manual (Page 20)

20
q If necessary, change the spin
speed with the Spin selection
button until the the desired spin
speed indicator light is lit.
q If necessary, change the Start
time. Press the Delay Start button
until the desired Start time is
displayed.
q Press the Start/Pause button.
The indicator light is lit (red).
Display shows the run time of the
selected program. The program
starts.
i Each program step is indicated by
the indicator lights under the
display.
During Washing
i Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
q Turn the program selector to Off.
q Turn the program selector to a
newly selected program.
The Start/Pause indicator light
flashes.
q If required, change the settings;
see from Page 18.
q
Press the Start/Pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
i It is not recommended to add
laundry after the washing phase is
complete.
i You can add or reduce laundry as
long as the
Start/Pause indicator
light flashes (red).
q Press the Start/Pause button.
The Start/Pause indicator light
flashes.
q Open the door.
q Place/remove the laundry.
q
Close the door.
q Press the Start/Pause button.
The program continues.
The indicator light is lit (red).
i When the Start/Pause indicator
light is lit (red), the program can be
interrupted, however the door
cannot be opened for safety
reasons (water level, temperature
or speed too high).
i If the spin speed is too high, the
Start/Pause indicator light is lit
(red). Laundry can be added in
Pause" mode when the drum is at
a standstill.
Canceling an active
program
If you would like to terminate a program
and remove the laundry:
i If a program is interrupted at a high
temperature, leave the laundry to
cool down until the glass is cool to
touch.
q Turn the program selector to Off.
q Turn the program selector to
Refresh.
i Select the desired spin speed (but
not
no final spin).
q Press the Start/Pause button.
q Wait until this program ends.
q Open the door.
q Unload the laundry.
i If a program is interrupted at a high
temperature, the door may remain
locked until the appliance has
cooled down.
i If the program is terminated by
switching off the appliance, the
door may remain locked.