Burley SOLO - Manual (Page 6)

6
Burley Solo Owner’s Instruction and Safety Manual
Check that the frame locks are properly engaged before
using trailer. Failure to do so can result in serious injury.
Installation and Use of the Cover
Your Big Screen 2-in-1 Cover is held in place by four snaps at the rear and top, and
two rubber O-rings in the front. Always use your cover to keep debris out (and toys
inside) of the trailer when it’s in use.
Installing the Cover
To install the cover, unfold it and
snap the top two snaps fi rst. Next,
pull the cover toward the back of
the trailer and snap the two rear
snaps. Finally, using the B-tabs in
front, pull the cover taut by looping
the O-rings over the edge of the
frame rails as shown below.
Folding and Stowing the Front Window
Folding and stowing the front window is quick and easy. Begin by unzipping the
window. Next, fold the window in half toward the back of the trailer. Then roll the
window up toward the top of the trailer. Hold the window in place by inserting the
elastic straps into the Velcro holders on the top of the trailer.
Using the Adjustable Sunscreen
Your Burley Solo™ is equipped with an
adjustable sunscreen to keep your kids in the
shade during bright, sunny days. To move
the Adjustable Sunscreen, simply pull on the
tabs to move it up or down on the trailer as
necessary. If more visibility is required, pull
the sunscreen up in the middle. This is depicted
in the illustration at right.
B-tabs
Frame Rails
B-tab
Adjustable
Sunscreen