Bel Canto Design PRePro - Manual (Page 4)

Page 4 © 2002/2003 bel canto design, Ltd. PRePro User’s Guide rev1103
Speaker Size
QUICK SETUP SPEAKER SIZE
This menu section defines how the PRePro treats
the audio signal that goes to the speakers. On
larger full range speakers where no bass signal
limiting is needed you will select LARGE. For
small speakers needing a high pass crossover,
SMALL should be selected.
1 FRONT SMALL
2 CENTER SMALL
3 SURROUND SMALL
4 BACK 2 SMALL
5 SUBWOOFER YES
6 CROSSOVER 80 Hz
EXIT
After 220 hz it will return to NONE indi-
cating no crossover, then to 60 Hz and
continuing upward. This permits
crossover frequencies from 60 Hz to 220
Hz in 10 Hz intervals with the default
setting at 80 Hz.
1. From MAIN MENU press selection 1.
2. Press 1 to set up FRONT speakers. Size
selection will blink (SMALL or LARGE).
3. Press SELECT button on right side of the
screen to toggle SMALL (high pass) or
LARGE (full range).
4. Press 2 and SELECT size for CENTER.
5. Press 3 to set up SURROUND speakers.
6. Press SELECT button to toggle SMALL or
LARGE (only available if LARGE selected for
front) or NONE.
7. Press 4 to setup BACK speaker(s).
8. Press SELECT button on right side of screen
to toggle and select 2 SMALL (7 or 7.1 sys-
tem, 1 SMALL (6 or 6.1 system), 2 LARGE or
1 LARGE (only available if LARGE selected
for front).
9. Press 5 to select SUBWOOFER, either YES
or NO.
10. Press EXIT button on lower left to store
changes and return to MAIN MENU.
11. Press 6 to select crossover frequency, use
the Select button to increment the crossover
frequency in 10 Hz increments to 220 Hz.
SPEAKER SPEAKER SIZE
1 FRONT
2 CENTER
3 SURROUND
4 BACK
5 SUBWOOFER
6 CROSSOVER
1 QUICK SETUP SPEAKER SIZE
2 QUICK SETUP SPEAKER DIST
3 INPUT ASSIGNMENT
4 TUNER/PAL/NTSC SETTING
5 BASS TRIM
6 CALIBRATION
7 COMPRESSION-
OFF
8 STATUS DISPLAY ON
9 DVD AUDIO FULLRANGE NO
0 RESET TO DEFAULTS NO
EXIT