Bel Canto Design PRePro - Manual (Page 22)

Page 2 2 © 2002/2003 bel canto design, Ltd. PRePro User’s Guide rev1103
Power up unit
1. Press MASTER power button all the way
in. This turns on the power and puts the
unit in standby. Do not turn the unit
off by pressing this button. Press
the OFF button on the right of the font
panel.
Turn unit on and off
1. Press any INPUT button on the front
panel or on the remote. It will select the
input and turn the unit on.
2. To turn the unit off press the OFF button
on the front panel or the POWER button
on the remote.
Mute the unit
1. Press the MUTE button on the front panel
or press the MUTE button on the remote.
When the system is in mute the unit will
not respond to any commands except the
mute command.
2. To un-mute press the MUTE button again
on the front panel or the remote.
Volume control
1. Press volume up or down on the remote
or front panel.
Modes
1. MUSIC 7. Press this button and the system
will go into MUSIC 7 from a PCM source
with no flag or analog input. It has no
effect with a multi-channel digital input.
2. STEREO mode works by pressing the stereo
button on the remote. When you press the
stereo button it will take you out of any multi
channel processing and put you into stereo
mode. If it is a DOLBY Digital input it will
mix down to DOLBY 2 channel.
3. SURROUND button. When you have an
analog stereo 2 Ch. or PCM Input and
you press the surround button, it will put
the PRePro in the surround mode.
4. MODE button. This button selects between
Dolby Prologic logic2: Music, Dolby
Prologic logic2: Movie, DTS Neo6:
Music, or DTS Neo6: Cinema as the
default for 2-Channel Sources with no
flags.
5. 7.1 input. When you press 7.1 from front
panel or remote the unit will select the
DVD video input and the 7.1 audio input.
6. To put 7.1 audio in the full range mode
(no filters) press MENU and press 9 to
toggle full range YES or NO press
SELECT when YES or NO is blinking.
Tuner
1. To select a station on the tuner press
SEEK UP or DOWN until you have the
desired station. Then press the desired
preset button 1 through 10 round button
on the remote or front panel and hold
down until the sound comes back.
Release the button and your preset is set.
2. After you have set all your favorite sta-
tions use the preset buttons to select sta-
tions.
3. The tuner should use a 75 ohm antenna
for FM, and an AM antenna.
Note: The seek is set very sensitive so you
can get weak stations, but there will be
noise on weak stations.
Main Zone Triggers
1. The PRePro has 2 main zone triggers.
One is 12-Volt 200 mA and the other is
a dry contact relay at 1 Amp. The relay
delay is 5 seconds before the main zone
is turned on. When main zone is turned
off, 12 Volts is off and the relay opens.
Infra Red Input
1. IR input allows a repeater or blaster input
from Zone 2 or any other IR input.
Replacing the AC Power Fuse
1. Turn the unit off.
2. Disconnect the AC power cord.
3. Slide open the fuse drawer completely.
4. Replace with 250V 1 Amp Slo-blo fuse.
General Operation of Unit