Whirlpool LTE5243DQ - Manual (Page 9)

9
ELECTRICAL REQUIREMENTS
The latch under the dryer will keep the lid open. Keep the
foam ring and use it when transporting your washer/dryer.
This packing material is used to keep the washer drum stable
during transport.
1.
Open washer lid and pull out foam
packing ring
REMOVE FOAM PACKING
Push legs into holes in rear corners until they snap into
place. Check adjustability of rear legs by pushing in one leg.
The other leg should come out. Check both legs. If they do
not move freely, remove legs and repeat this step.
To avoid floor damage, set washer/dryer onto cardboard before
moving across floor. Move washer/dryer close to its final location.
Gently place the washer/dryer on its side, on the cardboard.
INSTALL LEVELING LEGS
1.
Install rear leveling legs
Examine the front leveling legs. Find the diamond marking.
Screw front legs by hand into the holes in the triangular braces
in the front corners. Use wrench to finish turning the legs until
the diamond marking is no longer visible. Slowly stand the
washer/dryer upright.
2.
Install front leveling legs