Whirlpool W10153554 - Manual (Page 9)

9
ASSEMBLE ACCESSORY GRILLE
One-piece Accessory Grille
To assemble the accessory grille, follow these steps:
1. Insert the T-bolts and nuts into the top and bottom pieces of
the frame.
2. Attach one end cap to the top and bottom pieces of the
frame, and secure it with the T-bolts and nuts.
NOTE: Be sure the hooks on the end cap point toward the
bottom piece of the frame.
3. From the open end of the frame, insert the T-bolts without
nuts into the top and bottom pieces of the frame. Attach the
mounting bracket to the T-bolts using the nuts, but do not
fully tighten them.
NOTE: Be sure the hooks on the end cap point toward the
bottom piece of the frame.
4. Slide the mounting bracket toward the center of the frame.
The center of the hook on the bracket should be 36"
(91.4 cm) from the outside edge of the frame as shown.
Tighten the nuts on the T-bolts.
5. Slide the custom panel or acrylic and filler panels into the
open end of the frame.
NOTE: Only kits with an acrylic panel require a filler panel.
6. Insert the remaining T-bolts and nuts into the top and bottom
pieces of the frame.
7. Attach the other end cap and secure it with the T-bolts and
nuts.
Two-piece Accessory Grille
To assemble the louver panel and accessory grille, follow these
steps:
1. Place the louver panel on a clean, nonabrasive surface.
2. Install a tab bracket on each end using the screws provided,
making sure the tabs are aligned properly.
3. Place the accessory grille face down on a clean, nonabrasive
surface.
4. Attach the mounting bracket to the back of the accessory
grille as shown.
A. Bottom piece of the frame
B. T-bolts and nuts
C. End cap
D. Top piece of the frame
A. T-bolts and nuts
B. Hook
C
B
A
D
B
A
36"
(91.4 cm)
A. Filler panel
A. Louver panel
B. Tab bracket
C. Bracket mounting screw
A. Mounting bracket screw
B. Mounting bracket
A
A
B
C
A B