beautypg.com

Whirlpool W10153554 User Manual

Page 6

background image

6

Connect the Wiring

IMPORTANT: See the “Wiring Connection Diagram” while
performing the following procedure.

1. Locate the two-pin connector with the black wire and white

wire at the front of the compressor compartment.

2. Disconnect the two-pin connector with the black wire and

white wire.

3. Connect the new two-pin black wire and white wire provided

in the kit to the existing two-pin connector as shown.

4. Connect the new black wire and white wire to the transformer

as shown.

5. Connect the green ground wire to the transformer and to the

ground screw as shown.

6. Connect the heater wires (orange wire and black wire) to the

transformer as shown. Do not connect the heater wires to the
heaters until the refrigerators are in their final locations.

NOTE: Route the heater wires (orange wire and black wire)
around to the front of the compressor compartment where
they will exit through a notch in the bottom of the
compressor compartment cover.

7. Replace the compressor compartment cover.

NOTE: Route the heater wires (orange wire and black wire)
through the notch at the front of the compressor
compartment cover as shown. Be sure the wires are not
kinked or pinched.

A. Two-pin connector with black wire and white wire

A. Existing two-pin connector with

black wire and white wire

B. New two-pin connector with

black wire and white wire

A

A

B

A

A. Green ground wire
B. Black wire and orange wire

C. Black wire and white wire

A

B

C