Whirlpool W10153554 User Manual

Page 5

Install the Transformer

1. Locate the Transformer Mounting Template included on the

back cover of these Installation Instructions.

2. Position the template at the back of the condenser cover,

using the two condenser cover screws as your guides.

3. Push the template down over the condenser cover screws to

hold it in place. Mark the locations for the transformer
mounting screws as shown.

4. Center punch the locations for the transformer mounting

screws.

5. Position the transformer on the condenser cover as shown.

Install the transformer using the self-drilling screws provided.

NOTE: Do not drill into the condenser cover. You could
damage the condenser. Use the self-drilling screws provided.

Attach the Heaters

Locate the two foil-type heaters from the kit. Install one heater on
each refrigerator.

NOTE: The heaters will be between the two refrigerators when
they are moved into their final locations.

1. Align the bottom of the heater with the seam at the bottom of

the refrigerator.

2. Position the heater so the edge overlaps the cabinet side

trim, making sure one heater wire is touching the trim.

NOTE: The right-hinge refrigerator is shown.

3. Peel the backing off of the heater and adhere it to the side of

the refrigerator.

4. Tape the wires to the side of the refrigerator near the top to

aid in making the final wire connections after the refrigerators
are moved into their final locations.

A. Transformer mounting screw locations
B. Condenser cover screws

C. Back of the refrigerator

A. Transformer self-drilling screws

A. Heater wires taped to refrigerator
B. Heater wire touches cabinet side trim

C. Bottom of heater aligns with bottom seam