Whirlpool W10153554 - Manual (Page 4)

4
INSTALLATION INSTRUCTIONS
Remove Existing Top Grilles
One-piece Grilles
1. Grasp both ends of the top grille.
2. Push the top grille straight up and pull straight out from the
cabinet side trim.
3. Remove the top grille from the second refrigerator and
discard both top grilles.
Two-piece Grilles
1. Grasp both ends of the louver panel.
2. Push louver panel straight up and pull straight out from the
cabinet side trim.
3. Grasp both ends of the top grille.
4. Push the top grille straight up and pull straight out from the
cabinet side trim.
5. Remove the louver panel and top grille from the second
refrigerator.
6. Discard both louver panels and top grilles.
Install the Heaters
To install the heater kit, you will need to disassemble the
compressor cover on the left-hinge refrigerator only. You will not
need to disassemble the compressor cover on the right-hinge
refrigerator.
Remove the Compressor Cover
1. Remove three screws from the front and side of the
compressor cover on the left-hinge refrigerator as shown.
2. Remove six screws from the side and bottom back of the
compressor cover as shown.
3. Lift the compressor cover up and off of the refrigerator.
A. Top grille
B. Cabinet side trim
A. Top grille
B. Cabinet side trim
C. Louver panel
B B A
A B B
C
A. Compressor cover
B. Compressor cover screws
A. Compressor cover screws
WARNING
Electrical Shock Hazard
Disconnect all power supplies before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
B
B
A
A
A
A
A