Neff C47C22N3GB - Manual (Page 10)

10
Operating the appliance
In this section, you can read about
■
how to fill the water tank
■
how to switch the appliance on and off
■
what to note after each cooking operation
Filling the water tank
When you open the appliance door, you will see the water tank
on the right-hand side.
Caution!
Use of unsuitable liquids may damage the appliance
■
Only use fresh tap water, softened water or uncarbonated
mineral water.
■
If your tap water is very hard, we recommend that you use
softened water.
■
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
You can obtain information about your tap water from your
water supplier. The water hardness can be checked with the
test strips enclosed.
Fill the water tank before each use:
1. Open the appliance door and take out the water tank (fig. A).
2. Fill the water tank with cold water up to the “max” mark (fig.
B).
3. Close the tank cover until you feel it engage.
4. Slide in the water tank all the way (fig. C).
The tank must be flush with the water tank recess (fig. D).
Switching on the appliance
:
Risk of scalding!
When you open the appliance door and remove the cooking
containers, hot liquids may squirt out because the cooking
containers may have warped. When opening, do not stand too
close to the appliance. Open the appliance door carefully.
Remove the cooking container carefully. Keep children at a
safe distance.
Note: Always use the cooking container and wire rack in their
standard position (not the other way up).
1. Press the operating mode selector so that it pops out.
The appliance switches on.
2. Turn the operating mode selector until the required operating
mode lights up.
A default temperature appears on the temperature display.
3. Turn the temperature selector to change the default
temperature.
For operating modes that use steam, a default cooking time
appears in the clock display. The
KJ and x (cooking time)
symbols light up.
4. Turn the rotary selector to change the default cooking time.
The new cooking time is saved automatically after 3 seconds.
You can also set the cooking time for operating modes that
do not use steam (see section: Electronic clock).
5. Press the Start button.
If you do not press the Start button, an audible signal sounds.
When é Steam cooking, the cooking time does not start until
the heating up time has elapsed.
Heating indicator
The heating indicator displays the rising temperature in the
cooking compartment.
■
Temperature reached (fig. A)
■
Appliance reheating (fig. B)
Current temperature
Press the
± info button.
The current temperature is displayed for 3 seconds.
PD[
% $
' &
Operating mode Temperature range Default cooking
time
é Steam cooking 35 - 100 °C 20 minutes
8 CircoSteam® 120 - 230 °C 30 minutes
3 Hot air 30 - 230 °C -
ä Reheat 80 - 100 °C 10 minutes
$ %