Neff B45C52N3GB - Manual (Page 4)

Only connect the hob according to the connection diagram. The
connection diagram is on the back of the appliance. See the
rating plate for the voltage.
To connect the appliance, place it in front of the kitchen unit.
The service cable must be long enough.
Securing the appliance
The gap between the appliance door and the side fascia panels
can be adjusted using the left and right adjustment
screws- fig. 5.
1. Fully insert the appliance. Do not kink or trap the power cable,
or route it over sharp edges.
2. Centre the appliance.
There must be an air gap of 5 mm between the appliance and
adjacent cabinets - fig. 6a.
3. Using a spirit level, adjust the appliance so that it is perfectly
level.
4. Open the appliance door slightly and unscrew the left and right-
hand fascia panels - fig. 6b.
5. Fasten the appliance to the furniture units - fig. 6c.
6. Open the appliance door slightly. Refit the fascia panels and
screw them in place, first at the top and then at the bottom.
Removal
1. Disconnect the appliance from the power supply.
2. Open the appliance door slightly and unscrew the left and right-
hand fascia panels.
3. Undo the securing screws.
4. Lift the appliance slightly and pull it out completely.