Nokia 6110 Navigator - Manual (Page 86)

86
When the wireless device is in the remote SIM mode, you can only use a compatible
connected enhancement, such as a car kit, to make or receive calls. Your wireless device will
not make any calls, except to the emergency numbers programmed into your device, while in
this mode. To make calls from your device, you must first leave the remote SIM mode. If the
device has been locked, enter the lock code to unlock it first.
Send data
There can be only one active Bluetooth connection at a time.
1. Open an application where the item you wish to send is stored.
2. Scroll to the item you want to send, and select Options > Send > Via
Bluetooth .
The device starts to search for devices within range. Paired devices are shown
with .
When searching for devices, some devices may show only the unique device
addresses. To find out the unique address of your device, enter the code
*#2820# in the standby mode.
If you have searched for devices earlier, a list of the devices that were found
previously is shown first. To start a new search, select
More devices .
3. Select the device with which you want to connect.
4. If the other device requires pairing, enter a passcode (1-16 digits) and agree
with the owner of the other device to use the same code.
When the connection has been successfully established, Sending data is displayed.
Data received using Bluetooth connection can be found in Inbox in Messaging .
Paired devices view
Paired devices are indicated by in the search result list. In the Bluetooth main
view, scroll right to open a list of paired devices.
Do not accept Bluetooth connections from sources you do not trust.
To pair with a device, select Options > New paired device . Select the device with
which to pair. Exchange passcodes.
To cancel pairing, scroll to the device whose pairing you want to cancel and press
the clear key. If you want to cancel all pairings, select
Options > Delete all .
To set a device to be authorized ( ) and automatically allow connections
between your phone and the device without accepting the connection, scroll to