beautypg.com

Security, Ee "security, E "security," p. 74. the pin code is usually suppl – Nokia 6110 Navigator User Manual

Page 74

background image

74

Default profile

— to select the profile you want to activate each time you connect

the enhancement to your device

Automatic answer

— to set the device to answer an incoming call automatically

after 5 seconds when this enhancement is connected to your device. If the

Ringing

type

is set to

Beep once

or

Silent

, automatic answer cannot be used, and you must

answer the call manually.

Lights

— to set the device lights continuously on while using the enhancement,

select

On

.

Security

Select

Phone and SIM card

,

Certificate management

, or

Security module

.

Phone and SIM card

You can change the following codes: lock code, PIN or UPIN code, and PIN2 code.
These codes can only include the numbers from 0 to 9.

Avoid using access codes similar to emergency numbers to prevent accidental
dialing of the emergency number.

Code in use

— to select the active code,

PIN

or

UPIN

, for the active USIM. This is

shown only if the active USIM supports UPIN, and the UPIN is not rejected.

PIN code request

or

UPIN code request

— to set the device to request the code

each time the device is switched on. Some SIM cards may not allow the PIN code
request to be turned

Off

. If you select

Code in use

>

UPIN

,

UPIN code request

is

shown instead.

PIN code

or

UPIN code

,

PIN2 code

, and

Lock code

— to change the codes

Keypad autolock period

>

User defined

— to automatically lock the keypad after a

defined period of inactivity

Phone autolock period

— to set a time-out after which the device is automatically

locked. To use the device again, you need to enter the correct lock code. To turn off
the autolock period, select

None

.

Lock if SIM card changed

— to set the device to prompt for the lock code when an

unknown, new SIM card is inserted into your device. The device keeps a list of SIM
cards that are recognized as the owner cards.

Closed user group

(network service) — to specify a group of people whom you can

call and who can call you. For more information, contact your service provider. To
activate the default group agreed on with the service provider, select

Default

. If