Billion Electric Company 800VGT - Manual (Page 137)

Billion 800VGT Router
Bridge Interface VLAN Port (Always starts with)
Ethernet P1 / P2 / P3 / P4
Ethernet1 P2 / P3 / P4
Ethernet2 P3 / P4
Ethernet3 P4
Step 2: Create WAN Interface
Go to Configuration WAN ISP
wanlink is the factory default WAN interface which is used for data/internet access. If your ISP uses this
access protocol, click Edit to input other parameters if needed. If your ISP does not use PPPoE, you
can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to change
the VPI/VCI to 0/40. In South Africa, we use 8/35 for data by default.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN’s are supported;
therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 are assigned for video using 1483 Bridged mode. Select RFC 1483
Bridged and click Next to continue the setup.
137
Chapter 4: Configuration