Toshiba Equium M100 (PSMA8) - Manual (Page 123)

User’s Manual 9-12
Troubleshooting
Standby/Hibernation
Memory expansion
Refer also to Chapter 8, Optional Devices , for information on installing
memory modules.
Modem
Problem Procedure
The system will not
enter Standby/
Hibernation
Is Windows ® Media Player executed? The system
might not enter Standby/Hibernation, if Windows ®
Media Player is either playing a selection or
finished playing a selection. Close Windows ®
Media Player before you select Standby/
Hibernation.
If problems persist, contact your dealer.
Problem Procedure
The computer hangs up
and issues beep
sounds. (A long beep,
three short beeps, three
short beeps, and then a
long beep.)
Make sure the memory module installed in the
expansion slot is compatible with the computer.
If an incompatible module has been installed,
follow the steps below.
1. Turn off the power.
2. Disconnect the AC adapter and all peripheral
devices.
3. Remove the battery pack.
4. Remove the memory module.
5. Replace the battery pack and/or connect the
AC adapter.
6. Turn on the power.
If problems persist, contact your dealer.
Problem Procedure
Communication
software can't initialize
the modem
Make sure the computer's internal modem
settings are correct. Refer to Phone and Modem
Options Properties in the Control Panel.
You can hear a dial tone
but can't make a call
If the call is going through a PBX machine, make
sure the communication application's tone dial
detection feature is disabled.
You place a call, but a
connection can't be
made
Make sure the settings are correct in your
communications application.
After making a call you
can't hear a ring
Make sure the tone or pulse selection in your
communications application is set correctly.