Toshiba NB200 - Manual (Page 100)

User’s Manual 8-7
Optional Devices
4. Lift off the memory module cover.
5. Push the latches outward and the memory module will pop up.
6. Grasp the memory module by the sides and pull it out.
7. Seat the memory module cover in place and secure it with one screw.
8. Install the battery pack - refer to
Replacing the battery pack section in
Chapter 6, Power and Power-up Modes , if required.
9. Turn your computer over.
Battery Packs
You can increase the portability of the computer with additional battery
packs so that, if you're away from an AC power source and your battery
runs low, you can replace it with a freshly charged battery. Please refer to
Chapter 6, Power and Power-up Modes for further information.
Universal AC Adaptor
If you frequently use your computer at more than one site, it may be
convenient to purchase an additional AC adaptor to be kept at each site in
order to remove the need to always carry the adaptor with you.
External SuperMulti Optical drive
The external optical disc drive module can be connected to one of the USB
ports.
External monitor
An external analog monitor can be connected to the computer's external
monitor port, with the computer supporting WSVGA video mode. In order to
connect a monitor, follow the steps as detailed below:
1. Connect the monitor cable to the external monitor port .
Connecting the monitor cable to the external monitor port
2. Turn the external monitor’s power on.
1. External Monitor port 2. Monitor cable
2
1