Bosch WTA 4410 CN - Manual (Page 18)

18
Program selection
For optimum drying results your
dryer offers several program groups
and additional options.
Select the required drying program
from the program table according
to the examples (see page 19).
Automatic programs
There are automatic programs for
different types of textiles.
(Regular/Cotton or Permanent
Press).
Regular/Cotton
Permanent Press
The program sequence of
automatic programs is controlled
via sensors. The duration of the
program depends on the measured
degree of moisture in the laundry
and on the selected degree of
dryness (e.g. damp dry or extra dry).
Time programs
Time programs run for a specific
time (20, 30, 40, 50, 60 minutes).
In the "Air fluff" stage the dryer runs
on ambient air without a heat
supply for 10 minutes.
Options
Delicates
Press the Delicates button for
temperature sensitive textiles.
Observe the care information or
symbols on the textiles.
The temperature of the drying
process is reduced, the drying time
is extended.
Signal
Your dryer signals the start and
the end of drying programs,
if the Signal button is pressed.
Indicator of program
sequence
The dryer uses an electronic
scanning system for all programs
except the time programs.
A moisture sensor continuously
checks the moisture in the laundry.
Drying ends automatically as soon
as the selected degree of dryness
has been reached.
The current degree of drying and
the level reached during the
program sequence is indicated
via indicator lights (drying, damp
dry, regular dry, wrinkle block/ end).
Timer programming
function
The program can be set to start up
to 19 hours later. This time is
adjustable in 1 hour increments.
See also page 21 Programming
the timer".