Bosch WTA 4410 CN - Manual (Page 12)

12
Check list before
using the dryer
1. Check that steps 1-9 have
been implemented properly.
2. Ensure that the dryer is
connected to the power supply.
3. Read the operating instructions
to understand how your dryer
operates.
4. Conduct an appliance test:
q Check that the drum is
empty.
q Close the dryer door.
q Switch the dryer to "Extra
Dry" and then press the
Start button.
q After 3-5 minutes switch the
dryer to "Off" and open the
door.
5. If the interior of the dryer feels
warm, the dryer has been
connected properly.
6. If the dryer does not work,
switch the dryer to "Off".
Look in the troubleshooting
section (page 23) of the
OPERATING INSTRUCTIONS
and find the problem.
Preparing to transport
the dryer ć step
by step
1. Rotate the program selector
to "Off".
2. Pull out the power supply plug.
3. Disconnect the exhaust air duct
from the exhaust air outlet on
the dryer.
4. Place any accessories in the
drum.
5. Close the door and secure with
adhesive tape.
6. Screw the heightĆadjustable
feet of the dryer into the
housing to prevent them from
being damaged during
transportation.