Toshiba Satellite M40 (PSM42) - Manual (Page 158)

User’s Manual 9-19
Troubleshooting
Standby/Hibernation
LAN
Communication is cut
off unexpectedly
The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval.
Try lengthening this time interval.
A CONNECT display is
quickly replaced by NO
CARRIER
Check the error control setting in your
communications application.
You can also use the AT\N command. Refer to
the chapter on AT commands in online help files
for Appendix C , AT Commands.
Character display
becomes garbled
during a communication
In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
You cannot receive an
incoming call
Check the rings before auto answer setting in an
incoming call your communications application.
You can also use the ATS0 command. Refer to
the chapter on S-registers in online help files for
Appendix D , S-registers.
If problems persist, contact your dealer.
Problem Procedure
Problem Procedure
The system will not
enter Standby/
Hibernation
Is Windows Media™ Player open? The system
might not enter Standby/Hibernation, if Windows
Media Player is either playing a selection or
finished playing a selection. Close Windows
Media Player before you select Standby/
Hibernation.
If problems persist, contact your dealer.
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN Make sure the AC adaptor is connected. The
does not work Wake-up on LAN function
consumes power even when the system is off.
If problems persist, consult your LAN
administrator.