Brother FAX 750 - Manual (Page 31)

21
I N I T I A L S E T U P
2 Press or to select VOL AMPLIFY:OFF? if none of the users are
hearing-impaired and go to Step 4—OR—If some or all of the users are
hearing-impaired, select VOL AMPLIFY:ON?.
SELECT <- -> & SET
PERMANENT?
3 Press or to select PERMANENT? if all the users are hearing-
impaired—OR—Select TEMPORARY? if only some of the users are
hearing-impaired.
4 Press Set .
5 Press Stop to exit.
Setting the Speaker Volume
You can adjust the speaker volume when your fax machine is onhook (after
you pressed
Hook ), by selecting a speaker volume level.
Press or to adjust the volume level. The display shows the setting
you are choosing. Each key press changes the volume to the next setting.
The new setting will remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your fax machine is idle. You can
select a ring volume level or press until the ring is off.
Press or to adjust the volume level. With each key press, the
fax machine rings so you can hear the current setting and the display shows
the setting you are choosing. Each key press changes the volume to the next
setting. The new setting will remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the INITIAL SETUP, SETUP
RECEIVE, SET AUTO DIAL and REMOTE FAX OPT plus the COVERPG
SETUP and COVERPAGE MSG (from SETUP SEND) functions are stored
permanently. You may have to reset the date and time.