Pioneer VSX-819H-S - Manual (Page 45)

The System Setup menu 06
45
En
English
Français
Italiano
Español
Nederlands
Deutsch
1 Press RECEIVER on the remote control,
then press the SETUP button.
An on-screen display (OSD) appears on your
TV. Use
/// and ENTER on the remote
control to navigate through the screens and
select menu items. Press
RETURN to confirm
and exit the current menu.
2 Select ‘Input Assign’ from the System
Setup menu.
3 Select ‘Component Input’ from the Input
Assign menu.
4 Select the number of the component
video input to which you’ve connected your
video component.
The numbers correspond with the numbers
beside the inputs on the rear of the receiver.
5 Select the component that corresponds
with the one you connected to that input.
Select between
BD, TV, DVR, MULTI (MULTI
CH IN) or OFF.
• Use / and ENTER to do this.
• If you assign a component input to a
certain function, any component inputs
previously assigned to that function will
automatically be switched off.
• Make sure you have connected the audio
from the component to the corresponding
inputs on the rear of the receiver.
• If you connect any source component to
the receiver using a component video
input, you should also have your TV
connected to this receiver’s
COMPONENT
VIDEO OUT output (down converting
component video is not possible after
assigning an input).
6 When you’re finished, press RETURN.
You return to the Input Assign menu.
System Setup
1.Auto MCACC
2.Manual SP Setup
3.Input Assign
Return
System Setup
1.Auto MCACC
2.Manual SP Setup
3.Input Assign
Return
3.Input Assign
Return
a.Component Input
3a.Component Input
Return
Component–1 BD
Component–2 [ TV ]
VSX-819H_MYS.book 45 ページ ２００９年１月１６日 金曜日 午後８時３４分