Pioneer VSX-819H-S - Manual (Page 38)

Listening to your system 05
38
En
Setting the Audio options
There are a number of additional sound
settings you can make using the
AUDIO
PARAMETER menu. The defaults, if not stated,
are listed in bold.
Important
• The AUDIO PARAMETER menu is not
available with MULTI IN input (see
Selecting the multichannel analog inputs
on page 40).
• Note that if a setting doesn’t appear
in the AUDIO PARAMETER menu, it is
unavailable due to the current source,
settings and status of the receiver.
1 Press RECEIVER on the remote control,
then press AUDIO PARAMETER button.
2 Use
/ to select the setting you want to
adjust.
Depending on the current status/mode of the
receiver, certain options may not be able to be
selected. Check the table below for notes on this.
3 Use / to set it as necessary.
See the table below for the options available for
each setting.
4 Press RETURN to confirm and exit the
menu.
BD TV
INPUT SELECT SOURCE
DVR
INPUT
TV CONTROL
RECEIVER
ZONE 2
ON/OFF ENTER
RETURN
AUDIO
PARAMETER
TUNER EDIT
TOOLS
MASTER
VOLUME
iPod CTRL
CATEGORY
BAND
MENU
HOME
MENU
SETUP
TOP
MENU
TUNE
TUNE
P R E S E T P R E S E T
RECEIVER
RETURN
AUDIO
PARAMETER
Setting What it does Option(s)
EQ
(Acoustic Calibration
EQ) Switches on/off the effect of Acoustic Calibration EQ. ON
OFF
S.DELAY
(Sound Delay) Some monitors have a slight delay when showing video, so
the soundtrack will be slightly out of sync with the picture.
By adding a bit of delay, you can adjust the sound to match
the presentation of the video. 0.0 to 9.0 (frames)
1 second = 25 frames
(PAL)
Default: 0.0
MIDNIGHT a Allows you to hear effective surround sound of movies at
low volumes. M/L OFF
MIDNIGHT
LOUDNESS a Used to get good bass and treble from music sources at
low volumes.
LOUDNESS
S.RTV b
(Sound Retriever)
When audio data is removed during the WMA/MP3 c
compression process, sound quality often suffers from an
uneven sound image. The Sound Retriever feature employs
new DSP technology that helps bring CD quality sound
back to compressed 2-channel audio by restoring sound
pressure and smoothing jagged artifacts left over after
compression.
OFF
ON
DUAL MONO d Specifies how dual mono encoded Dolby Digital
soundtracks should be played. CH1 –
Channel 1 is heard only
CH2 –
Channel 2 is heard only
CH1 CH2 –
Both channels heard
from front speakers
VSX-819H_MYS.book 38 ページ ２００９年１月１６日 金曜日 午後８時３４分