Pioneer DEH-80PRS - Manual (Page 5)

Switching between RCA
input modes
If you connect the unit to an audio device with
RCA output, or to one with no RCA output,
you can set it up so that the audio from the
audio device is output through speakers con-
nected to the unit. Change settings as neces-
sary based on whether the connected device
has RCA output or not.
! For more details on how to connect the
unit, refer to the installation manual.
% Use a thin, flathead screwdriver to
change the RCA input mode switch on the
bottom of this unit.
! L (Low) - If inputting from the RCA output of
a connected device
! H (High) - If inputting from the speaker out-
put of a connected device
Demo mode
Important
! Failure to connect the red lead (ACC) of this
unit to a terminal coupled with ignition switch
on/off operations may lead to battery drain.
! Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
The demo starts automatically if you do not op-
erate this unit within about 30 seconds since it
was last operated or if the ignition switch is
set to ACC or ON while it is turned off. To can-
cel the demo mode, press and hold (
/ DISP).
Press and hold ( / DISP) again to start. You
can also deactivate demo mode in the initial
settings. Select Demonstration (demo display
setting) and turn off the demo display. For de-
tails, refer to Initial settings on page 34.
About this manual
! In the following instructions, USB mem-
ories, USB portable audio players, and SD
memory cards are collectively referred to as
“external storage devices (USB, SD)”. If
only USB memories and USB portable
audio players are indicated, they are collec-
tively referred to as
“USB storage devices”.
! In this manual, iPod and iPhone will be re-
ferred to as
“iPod”.
En
5
Section
01
Before
you
start
Before you start