Pioneer DEH-80PRS - Manual (Page 26)

1 Use M.C. to select A.EQ in the audio
function menu.
Refer to Introduction of audio adjustments on
page 19.
# If auto TA and EQ has not been carried out,
Please set Auto EQ appears. This indicates that
you cannot turn this function on.
2 Press M.C. to turn the auto-equalizer
on.
Auto EQ ON appears in the display.
# To turn auto-equalizer off, press M.C. again.
Recalling equalizer curves
You can adjust the equalization to match the
car
’s interior acoustic characteristics as de-
sired.
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves.
Display Equalizer curve
Super bass Super bass
Powerful Powerful
Natural Natural
Vocal Vocal
Flat Flat
Custom1 Custom 1
Custom2 Custom 2
! Custom1 and Custom2 are adjusted equal-
izer curves that you create. Adjustments
can be made with a 16-band graphic equal-
izer.
! When Flat, no changes are made to the
sound. You can check the effects of the
equalizer curves by switching alternatively
between
Flat and another equalizer curve.
% Press EQ/DISP OFF to select the equali-
zer.
Press
EQ/DISP OFF repeatedly to switch be-
tween the following equalizers:
Powerful
—Natural—Vocal—Flat—Custom1
—Custom2—Super bass
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
Flat, can be adjusted to a fine de-
gree (nuance control).
1 Use M.C. to select EQ 1.
Refer to Introduction of audio adjustments on
page 19.
2 Turn M.C. to select an equalizer curve.
3 Turn LEVER to adjust the equalizer
curve.
+6 to
–6 is displayed as the equalizer curve is
increased or decreased.
# The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
# The equalizer curve with all frequencies set to
0 cannot be adjusted.
Adjusting the 16-band graphic
equalizer
You can adjust the level of each band for the
Custom1 and Custom2 equalizer curves.
! A separate Custom1 curve can be created
for each source. If you make adjustments
when a curve other than
Custom2 is se-
lected, the equalizer curve settings will be
recorded in
Custom1.
! A Custom2 curve that is common for all
sources can be created. If you make adjust-
ments when the
Custom2 curve is se-
lected, the Custom2 curve will be updated.
1 Recall the equalizer curve you want to
adjust.
Refer to Recalling equalizer curves on this
page.
2 Use M.C. to select EQ 2.
Refer to Introduction of audio adjustments on
page 19.
En
26
Section
02 Operating this unit