Playing and recording from a dv camcorder 08 – Pioneer LX01 User Manual

Page 115

Playing and recording from a DV camcorder

115

Select ‘Record to Hard Disk Drive’ or

‘Record to DVD’.

Find the place on the camcorder tape that you

want to start recording from.
For best results, pause playback at the point from which
you want to record.

• Depending on your camcorder, you can use this

recorder’s remote to control the camcorder using the
 ,  ,  ,  ,  ,  and  buttons (LCD page 1).

Select ‘Start Rec’.

• You can pause or stop the recording by selecting

Pause Rec or Stop Rec from the on-screen display.
You cannot control the camcorder from this remote
control during recording.

• If you restart recording after stopping the camcorder,

the first few seconds of the camcorder tape will not be
recorded. Use the pause button on your camcorder
instead and recording will start immediately.

• HDD, DVD (VR Mode) and DVD-RAM only: A chapter

marker is inserted every time there is a break in the
timecode on the DV tape. This happens when the
recording is stopped or paused then restarted, for
example.

• If you don’t want to see the DV recording screen

during recording, press

DISPLAY to hide it (press

again to display).

• While recording, you cannot exit the DV recording

screen using the

HOME MENU or RETURN button.

DV Auto Copy

DV Auto Copy allows you to make an exact copy of the
contents of a DV source to the HDD or a DVD.

Make sure your DV camcorder is connected to the

front panel DV IN jack.
Also, set the camcorder to VTR mode.

(LCD page 1) Set the recording quality.

• See Setting the picture quality/recording time on

page 95 for detailed information.

From the Initial Setup menu, check that the DV

audio input is setup as you require.
See DV Input on page 155 for more on this.

• Check also that the

Audio In settings for External

Audio and Bilingual Recording are as you want
them (see Audio In on page 155).

Select ‘DV’, then ‘DV Auto Copy’ from the

Home Menu.

• DV recording only works when the DV camcorder is

in VTR mode with a tape loaded.

Select ‘Record to Hard Disk Drive’ or

‘Record to DVD’.
The DV tape is rewound to the beginning. Once it is
rewound, the DV tape is played from the beginning and
copied to either the HDD or a DVD.

• If there is a gap of two minutes or more between

recorded contents, the copying process is
automatically stopped.

• Once copying is finished, the DV tape is automatically

rewound.

• To cancel the copying process, press

STOP REC (LCD

page 1) for more than three seconds.

ENTER

Start Rec

Pause Rec

Stop Rec

SP (2h00m/DVD)

32h45m

Stop

1.02.22

Control with these
buttons

Rem.

HDD

REC

MODE

HOME
MENU

SETUP

ENTER

02SDVRLX70D_EN.book 115 ページ２００８年１０月９日　木曜日　午後４時３８分