beautypg.com

Connecting the speakers, Flow of settings on the receiver, Placing the speakers – Pioneer VSX-322-K User Manual

Page 3

background image

English

Français

Italiano

Español

Nederlands

Deutsch

3

En

Connecting the speakers

Connecting the speakers
Connecting a TV and playback component
Plugging the receiver

CAUTION

• These speaker terminals carry HAZARDOUS LIVE voltage. To prevent

the risk of electric shock when connecting or disconnecting the
speaker cables, disconnect the power cord before touching any
uninsulated parts.

• Make sure that all the bare speaker wire is twisted together and

inserted fully into the speaker terminal. If any of the bare speaker
wire touches the back panel it may cause the power to cut off as a
safety measure.

Make sure you connect the speaker on the right to the right (R) terminal and the speaker on the left to the left (L) terminal. Also make sure the positive and negative (+/–)
terminals on the receiver match those on the speakers.
You can use speakers with a nominal impedance between 6

Ω and 16 Ω.

Be sure to complete all connections before connecting this unit to the AC power source.

Bare wire connections

Front speaker terminals:

1

Twist exposed wire strands together.

2

Loosen terminal and insert exposed wire.

3

Tighten terminal.

Center and surround speaker terminals:

1

Twist exposed wire strands together.

2

Push open the tabs and insert exposed
wire.

3

Release the tabs.

Placing the speakers

The receiver will work with just two stereo speakers (the
front speakers in the diagram) but using at least three
speakers is recommended, and a complete setup is
best for surround sound.
To achieve the best possible surround sound, install
your speakers as shown below.
5.1 channel surorund system:

R

SL

L

SW

C

SR

• In addition, surround back speakers can also be

connected.
l “Connect the surround back speakers”

1

2

3

1

2

3

Flow of settings on the receiver

VENTILATION CAUTION

When installing this unit, make sure to leave space
around the unit for ventilation to improve heat radiation
(at least 40 cm at top, 20 cm at rear, and 20 cm at each
side).

WARNING

Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the product, and
to protect it from overheating. To prevent fire hazard, the
openings should never be blocked or covered with items
(such as newspapers, table-cloths, curtains) or by
operating the equipment on thick carpet or a bed.

D3-4-2-1-7b*_A1_En

O

L

R

R

L

COAXIAL

AUDIO

SPEAKERS

ANTENNA

OPTICAL

ASSIGNABLE

OUT

A

CD-R/TAPE SURR BACK

PRE OUT

L

R

(Single)

(

CD-R / TAPE

)

IN

CD/SAT

TOR

T

CD/SAT

DVD

IN

TV

IN

IN

IN

DVD

DVD IN

BD IN

CD/SAT IN

(

TV

)

IN

1

IN

1

FM UNBAL

75

AM LOOP

CENTER

SURROUND

R

L

SUBWOOFER

PRE OUT

FRONT

R

L

OUT

LINE LEVEL

INPUT

Front Right

10 mm

10 mm

Center

Front Left

Subwoofer

Surround

Right

Surround

Left

Be sure to complete
all connections before
connecting this unit to
the AC power source.

The unit is a full-fledged AV receiver equipped with an
abundance of functions and terminals. It can be used
easily after following the procedure below to make the
connections and settings.

L

Front left

SW

Subwoofer

C

Center

This receiver

(VSX-322-K)

Blu-ray Disc

player

TV

R

Front right

SL

Surround left

SR

Surround right