Pioneer DEH-6100BT - Manual (Page 42)

Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Press SRC/OFF and hold until the unit
turns off.
2 Press SRC/OFF and hold until the initial
setting menu appears in the display.
3 Turn MULTI-CONTROL to select one of
the initial settings.
LANGUAGE (language selection)
—FM STEP
(FM tuning step)
—AUTO PI (auto PI seek)—
WARNING (warning tone)
—AUX (auxiliary
input)
—REAR SP (rear output and subwoofer
output)
—EVERSCROLL (ever scroll)—
BT AUDIO (Bluetooth audio)
—POWER SAVE
(power save)
—BT MEMORY CLR (clearing
Bluetooth memory)
—S/W UPDATE (software
update)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND/ESC.
Selecting the language
For your convenience, this unit equips multi-
ple language display. You can select the lan-
guage best suited to your first language.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select
LANGUAGE in the initial setting menu.
3 Push MULTI-CONTROL left or right to
select the language.
ENG (English)
—РУССКИИ (Russian)—
ESPANOL (Spanish)
4 Press MULTI-CONTROL to determine
the selection.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select FM STEP
in the initial setting menu.
3 Press MULTI-CONTROL to select the FM
tuning step.
Pressing
MULTI-CONTROL repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.
# The tuning step remains at 50 kHz during
manual tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Display the initial setting menu.
Refer to Adjusting initial settings on this page.
2 Use MULTI-CONTROL to select AUTO PI
in the initial setting menu.
3 Press MULTI-CONTROL to turn Auto PI
seek on.
# To turn Auto PI seek off, press
MULTI-CONTROL again.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
Initial Settings
En
42
Section
10