Pioneer DEH-6100BT - Manual (Page 39)

! When FLAT is selected, no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
the previous page.
2 Use MULTI-CONTROL to select P.EQ.
3 Push MULTI-CONTROL left or right to
select the equalizer.
Adjusting equalizer curves
The factory supplied equalizer curves can be
adjusted to a fine degree (nuance control).
1 Display the audio menu.
Refer to Introduction of audio adjustments on
the previous page.
2 Use MULTI-CONTROL to select EQ
(equalizer adjustment).
3 Push MULTI-CONTROL left or right to
select the equalizer band to adjust.
LOW (low)
—MID (mid)—HIGH (high)
4 Push MULTI-CONTROL up or down to
adjust the level of the equalization band.
+6 to
–6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (
LOW/MID/HI).
Level (dB)
Center frequency
Q=2N
Q=2W
Frequency (Hz)
1 Display the audio menu.
Refer to Introduction of audio adjustments on
the previous page.
2 Use MULTI-CONTROL to select EQ
(equalizer fine adjustment).
3 Push MULTI-CONTROL left or right to
select the frequency to adjust.
Low:
40HZ
—80HZ—100HZ—160HZ
Mid: 200HZ
—500HZ—1KHZ—2KHZ
High: 3KHZ
—8KHZ—10KHZ—12KHZ
4 Push MULTI-CONTROL up or down to
adjust the Q factor.
2W
—1W—1N—2N
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Display the audio menu.
Refer to Introduction of audio adjustments on
the previous page.
2 Use MULTI-CONTROL to select
LOUDNESS.
3 Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g.,
MID) appears in the dis-
play.
# To turn loudness off, press MULTI-CONTROL
again.
Audio Adjustments
En
39
Section
09
Audio
Adjustments