Pioneer SPX-HUD01 - Manual (Page 8)

Black plate (8,1)
Head-up display unit:
Main unit x 1
Mounting bracket x 1
Sun visor thickness adjustment
plate (large) x 1
Sun visor thickness adjustment
plate (small) x 1
Mounting screw x 6
Hexagonal spanner x 1
Power cable x 1
Sun visor cushion x 1
Double-sided tape x 1
HUD remote control:
Main unit x 1
(A lithium ion battery is preinstalled. Remove
the insulation sheet before using the unit.)
Precautions for connection
CAUTION
! Do not take accessory power from the CAN
Bus interface, etc. Be sure to connect to the
accessory power supply of the vehicle.
! Install the supplied parts as specified.
Use of parts other than the supplied ones
may cause a malfunction.
Connecting the power cable
! Firmly connect the power cable by inserting
it into the power connector on the unit. If the
connector cannot be inserted smoothly, the
orientation may not be correct. Check the ori-
entation of the connector. Do not use force
to push it in. Doing so may cause a malfunc-
tion.
Preventing noise
! To prevent noise, place the following items as
far from an iPhone, an Android device, and
other cables and cords as possible.
— Film aerial and aerial cable
— FM/AM aerial and its aerial cable
— GPS aerial and its aerial cable
— Beacon receiver and its aerial cable
— Power cable
Place the aerials as far from each other as
possible.
! Do not tie the aerials together, stack them, or
cross them over each other.
Noise received by the aerial and aerial cable
reduces reception sensitivity.
Parts supplied
8
Section
Before connection
Engb
03
04
8