Pioneer SPX-HUD01 - Manual (Page 12)

Black plate (12,1)
1 Align the HUD lock lever to the lock-re-
lease position.
Pull the HUD lock lever, and slide it to the lock-
release position.
1
2
1 Lock-release position
2 HUD lock lever
! Do not hold the moving part on the mounting
bracket when operating the HUD lock lever. If
holding the moving part, the HUD lock lever
cannot be moved.
1
1 Moving part
2 Release the lock plates on the mounting
bracket.
Pull the lock plates on the mounting bracket to
the left and right to release the lock.
3 Adjust the mounting bracket thickness.
Align the lines on the mounting bracket to the
scale marks located at the left and right on the
sun visor thickness adjustment plate according
to the thickness of the sun visor, and then tight-
en three screws.
1
1
2
1 Mounting bracket
2 Sun visor thickness adjustment plate
! The approximate figures for the scale marks
on the sun visor thickness adjustment plate
(medium) are as follows (the illustration
shows the line on the mounting bracket is
aligned to the scale mark of 22 mm).
1
2
3
4
1 20 mm
2 22 mm
3 24 mm
4 26 mm
4 Mount the mounting bracket to the sun
visor.
Push the sun visor up to the horizontal position.
Hold the left and right ends of lock plates on the
mounting bracket, and mount the mounting
bracket to the sun visor by pushing the mount-
ing bracket all the way in.
! If the mounting bracket cannot be fully
pushed in, the mounting bracket thickness
needs to be increased. Remove the mounting
bracket from the sun visor, return to step 3
and adjust the scale position, and then
mount the mounting bracket to the sun visor
again.
5 Push the sun visor down to the vertical
position.
6 Lock the mounting bracket.
Push in the lock plates from the left and right
firmly to lock the mounting bracket.
! If the lock plates cannot be fully pushed in,
the mounting bracket thickness needs to be
increased. Remove the mounting bracket
from the sun visor, return to step 3 and adjust
the scale position, and then mount the
mounting bracket to the sun visor again.
7 Check that the mounting bracket is
mounted securely.
Push the sun visor back to the horizontal posi-
tion.
Push the mounting bracket back and forth to
make sure that the mounting bracket is
mounted securely.
! If the mounting bracket can be removed from
the sun visor easily, the mounting bracket
thickness needs to be decreased. Remove the
mounting bracket from the sun visor, return
to step 3 and adjust the scale position, and
then mount the mounting bracket to the sun
visor again.
8 Remove the mounting bracket.
Push the sun visor down to the vertical position
and pull the lock plates to the left and right to re-
lease the lock.
Push the sun visor up to the horizontal position
and remove the mounting bracket from the sun
visor.
Installing Main Unit
12
Section
Installing Main Unit
Engb
09
12