Reducing video noise, Setting child lock, Selecting a decoder input terminal – Pioneer PDP-5080XA User Manual
Page 25: Setting up 08
Setting up
08
25
En
E
n
glish
15 Press HOME MENU to exit the menu.
• Alternatively, to set up for another channel, repeat steps 6 to 14.
Note
• The above procedure transfers and sets the selected channel
information to the connected recording equipment such as a
VCR or DVD/HDD recorder (DVR).
• Manual Adjust also allows you to make selections for Tuner NR,
Child Lock, and Decoder. See
Reducing video noise, Setting
Child Lock, and Selecting a decoder input terminal.
Reducing video noise
For the individual channels, you can specify whether the plasma
television should reduce video noise depending on the levels of
broadcasting signals.
1
Press HOME MENU.
2
Select “Setup” (
/ then ENTER).
3
Select “Analogue TV Setup” (
/ then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons
0 to 9. For the password, see Using a password on
4
Select “Manual Adjust” (
/ then ENTER).
5
Select “Programme Entry” (
/).
6
Select a programme number (
/).
You can select 1 through 99.
7
Select “Tuner NR” (
/).
8
Select “On” (
/).
9
Press HOME MENU to exit the menu.
Note
• This function may not achieve a satisfactory result, depending on
the conditions of broadcasting signals.
• When using a decoder with a decoder terminal selected, this
function may fail to achieve a good result.
• The factory default is “On”.
Setting Child Lock
Child Lock inhibits selected TV channels from being tuned and
watched.
1
Repeat steps 1 to 6 provided for Reducing video noise.
After selecting a channel (using Programme Entry), perform the
following steps:
2
Select “Child Lock” (
/).
3
Select “Block” (
/).
• The selection is switched between “View” (factory default) and
“Block”.
4
Press HOME MENU to exit the menu.
Selecting a decoder input terminal
If you have connected a decoder, select a decoder input terminal
(INPUT 1).
1
Repeat steps 1 to 6 provided for Reducing video noise.
After selecting a channel (using Programme Entry), perform the
following steps:
2
Select “Decoder” (
/).
3
Select “INPUT 1” (
/).
4
Press HOME MENU to exit the menu.
Note
• With “Off” (factory default) selected, you cannot watch any
images from the decoder.
Item
Description
Yes
You can select the channel using
P+/P–.
Yes (Listed)
Select this option to register the channel as your
favourite channel.
You can select the channel using the Favourite
Channel list and
P+/P–.
No
You cannot select the channel using
P+/P–.