Pioneer AVH-X8500BT - Manual (Page 67)

7 Plug the microphone into the micro-
phone input jack on this unit.
8 Touch Start to start auto EQ.
9 When the 10-second countdown starts,
get out of the car and close the door within
10 seconds.
A measurement tone (noise) is emitted from
the speakers, and auto EQ measurement be-
gins.
When auto EQ is completed,
The measure-
ment has finished. Please disconnect the
microphone and then push HOME key. is
displayed.
When the car
’s interior acoustic characteris-
tics cannot be measured correctly, an error
message will be displayed. (Refer to Under-
standing auto EQ error messages on page 80.)
# It takes about nine minutes for auto EQ mea-
surement to be completed when all the speakers
are connected.
# To stop auto EQ, touch Stop.
10 Store the microphone carefully in the
glove compartment or another safe place.
If the microphone is subjected to direct sun-
light for an extended period, high tempera-
tures may cause distortion, color change or
malfunction.
Selecting the video format
You can switch the video output format of V
OUT between NTSC and PAL.
1 Press the home button to switch to the
home display.
2 Touch the system key to open the sys-
tem menu.
3 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC
—PAL
Note
You can switch the video output format only for
the source from this unit.
Setting the video signal
When you connect this unit to an AV equip-
ment to this unit, select the suitable video sig-
nal setting.
! As this function is initially set to Auto, the
unit will automatically adjust the video sig-
nal setting.
! You can operate this function only for the
video signal input into the AV input.
1 Press the home button to switch to the
home display.
2 Touch the system key to open the sys-
tem menu.
3 Touch Video Signal Setting on the func-
tion menu.
Video Signal Setting items are displayed.
! AV – Adjusts the AV video signal
! AUX – Adjusts the AUX video signal
! Camera – Adjusts the rear view camera
video signal
4 Touch c or d to select the desired
video signal appears.
Auto
—PAL—NTSC—PAL-M—PAL-N—
SECAM
En
67
Section
17
System
settings
System settings