Pioneer VSX-1018AH-S - Manual (Page 73)

Using other functions 11
73
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel STEREO/A.L.C
button, press and hold  STANDBY/ON for about two
seconds.
The display shows RESET?.
3 Press the front panel AUTO SURR/STREAM DIRECT
button.
The display shows OK.
4 Press HOME THX to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting Default
HDMI Audio Amp
HDMI Control ON
Digital Video Conversion ON
Speakers A
Surround Back System Normal
Speaker System Front SMALL
Center SMALL
Surr SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
X-Curve OFF
THX Audio Setting 0.0–0.3m
Inputs
See Input function default and possible settings on page 66.
MULTI-ZONE
Zone 2 Volume Type Variable
Zone 2 Volume –60 dB
SR+
SR+ Control On/Off OFF
SR+ Volume Control On/Off OFF
Monitor Out OFF
DSP
Surround back channel Processing ON
Phase Control ON
Sound Retriever OFF
Sound Delay 0.0 frame
Dual Mono CH1
DRC OFF
SACD Gain 0 dB
LFE Attenuate 0 dB
I/P Convert AUTO
Auto delay OFF
Digital Safety OFF
Effect Level Extended Stereo 90
Other modes 50
2 PL II Music
Options Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image 3 (Neo:6 Music)
10 (Neo:6
Cinema)
All Inputs Listening Mode
(2 ch) AUTO
SURROUND
Listening Mode
(x ch) AUTO
SURROUND
Listening Mode
(HP) STEREO
See also Setting the Audio options on page 69 for other default
DSP settings.
MCACC
MCACC Position Memory M1: MEMORY 1
Channel Level (M1–M6) 0.0 dB
Speaker Distance (M1–M6) 3.00 m
Standing Wave
(M1–M6) ATT 0.0 dB
SWch Wide Trim 0.0 dB
EQ Data (M1–M6) All channels/bands 0.0 dB
EQ Wide Trim 0.0 dB
Setting Default
VSX-1018AH_HY.book 73 ページ ２００８年４月１６日 水曜日 午後７時２５分