Pioneer VSX-1018AH-S - Manual (Page 57)

Other connections 08
57
En
Connecting additional amplifiers
This receiver has more than enough power for any home
use, but it’s possible to add additional amplifiers to every
channel of your system using the pre-outs. Make the
connections shown below to add amplifiers to power
your speakers.
• Before making or changing the connections, switch
off the power and disconnect the power cord from the
AC outlet.
• You can use the additional amplifier on the surround
back channel pre-outs for a single speaker as well. In
this case plug the amplifier into the left (L (Single))
terminal only.
• The sound from the surround back terminals will
depend on how you have configured the Surround
back speaker setting on page 41.
• To hear sound only from the pre-outs, switch the
speaker system to OFF, or simply disconnect any
speakers that are connected directly to the receiver.
• If you’re not using a subwoofer, change the front
speaker setting (see Speaker Setting on page 48) to
LARGE.
MULTI-ZONE listening
This receiver can power up to two independent systems
in separate rooms after you have made the proper MULTI-
ZONE connections. An example MULTI-ZONE setup is
shown below.
Different sources can be playing in two zones at the same
time or, depending on your needs, the same source can
also be used. The main and sub zones have independent
power (the main zone power can be off while the sub zone
is on) and the sub zone can be controlled by the remote
or front panel controls. However, you may need to specify
the volume settings in ZONE Audio Setup on page 67.
Making MULTI-ZONE connections
It is possible to make these connections if you have a
separate TV and speakers for your sub zone (ZONE 2).
1
You will also need a separate amplifier if you are not
using the Surround Back System setup (page 58) for your
sub zone.
B
D-R
ANTENNA
PRE OUT IN
Y
P B
P R
MONITOR
OUT
FM UNBAL 75
O
FRONT CENTER
SURROUND SURROUND BACK /
L R
SURROUND SURROUND BACK
(Single)
3 IN
ASSIGNABLE
3 1 -
AM LOOP
L
(Single)
SUBWOOFER
SELECTABLE SEE INSTRUCTION MANUAL
SELECTABLE VOIR LE MODE D'EMPLOI
PRE OUT FRONT CENTER (Single)
SURROUND SURROUND BACK SUBWOOFER
INPUT
L R
ANALOG
INPUT
L R
ANALOG
INPUT
L R
ANALOG
INPUT
ANALOG
INPUT
ANALOG
Front channel
amplifier
Center channel
amplifier (mono)
Surround channel
amplifier
Surround back
channel amplifier
Powered
subwoofer
VSX-1018AH
Note
1 You can’t use sound controls (such as the bass/treble controls or Midnight listening) or any surround modes with a separate amplifier in the sub zone.
You can, however, use the features available with your sub zone amplifier.
A
SPEAKERS
CD CD-R
VR1
IN IN IN
Y
P
P
IN
DVR2 ZONE 2
IN
IN OUT
MONITOR
OUT
MONITOR
OUT
COMPONENT VIDEO
OUT
OUT
OUT OUT FRONT
FRONT CENTER SURROUND
R L R
SURROUND BACK
1 IN 2 IN 3 IN
ZONE 2
OUT
OUT
AUDIO IN
Sub zone Main zone
VSX-1018AH
VSX-1018AH_HY.book 57 ページ ２００８年４月１６日 水曜日 午後７時２５分