Pioneer VSX-1018AH-S - Manual (Page 71)

Using other functions 11
71
En
Making an audio or a video recording
You can make an audio or a video recording from the
built-in tuner, or from an audio or video source
connected to the receiver (such as a CD player or TV).
1
Keep in mind you can’t make a digital recording from an
analog source or vice-versa, so make sure the
components you are recording to/from are hooked up in
the same way (see Connecting your equipment on
page 12 for more on connections).
Since the video converter is not available when making
recordings (from the video OUT jacks) make sure to use
the same type of video cable for connecting your recorder
as you used to connect your video source (the one you
want to record) to this receiver. For example, you must
connect your recorder using S-Video if your source has
also been connected using S-Video.
For more information about video connections, see
Connecting a DVD/HDD recorder, VCR and other video
sources on page 17.
1 Select the source you want to record.
Use the input source buttons (or INPUT SELECT).
• If necessary, press SIGNAL SEL to select the input
signal corresponding to the source component (see
Choosing the input signal on page 32 for more on
this).
2 Prepare the source you want to record.
Tune to the radio station, load the CD, video, DVD etc.
3 Prepare the recorder.
Insert a blank tape, MD, video etc. into the recording
device and set the recording levels.
Refer to the instructions that came with the recorder if
you are unsure how to do this. Most video recorders set
the audio recording level automatically—check the
component’s instruction manual if you’re unsure.
4 Start recording, then start playback of the source
component.
Setting What it does Option(s)
V. CONV
(Digital
Video
Conversion) Converts video signals for output
from the MONITOR OUT jacks for
all video types. ON
OFF
BRIGHT
(Brightness) Adjusts the overall brightness. –10 to +10
Default: 0
CONTRAST Adjusts the contrast between
light and dark.
–10 to +10
Default: 0
HUE Adjusts the red/green balance. –10 to +10
Default: 0
CHROMA Adjusts saturation from dull to
bright. –10 to +10
Default: 0
IP.CNV
(I/P
Convert) When AUTO is selected, 480i/
576i or 480p/576p is automatically
selected depending on the
capability of the display
connected to this receiver. When
ON is selected, 480i/576i video
signals are upconverted into
480p/576p. This feature is only
available when analog signals are
converted into HDMI signals. AUTO
ON
OFF
Note
1 • The receiver’s volume, Audio parameters (the bass/treble controls, for example), and surround effects have no effect on the recorded signal.
• Some digital sources are copy-protected, and can only be recorded in analog.
• Some video sources are copy-protected. These cannot be recorded.
DVD BD TV HDMI
DVR 1 DVR 2 CD CD-R
DIMMER
FM/AM
1 2 3
SLEEP MCACC
INPUT
SELECT
GENRE
4 5 6
iPod USB
DVD BD TV HDMI
DVR 1 DVR 2 CD CD-R
FM/AM iPod USB
INPUT
SELECT
1 2
AUTO/
DIRECT
THX STATUS PHASE
TV CTRL
HDD
STEREO/
A.L.C.
DVD
STANDARD BD MENU
ADV SURR
DTV/TV
AUDIO DISPLAY
EON MPX SIGNAL SEL
CH
RECEIVER
SIGNAL SEL
VSX-1018AH_HY.book 71 ページ ２００８年４月１６日 水曜日 午後７時２５分