Pioneer PDP-LX5090 - Manual (Page 56)

Useful adjustment settings 11
56
En
Video Pattern
You can display the Video Pattern screen that also helps eliminate
after-image when it occurs.
1 Press HOME MENU.
2 Select “Option” ( / then ENTER).
3 Select “Video Pattern” ( / then ENTER).
A confirmation screen appears.
4 Select “Start” (ENTER).
The Video Pattern screen displays.
Note
• The system is automatically placed into standby one hour after
the Video Pattern screen has started.
• While the Video Pattern screen is on, no buttons operate except
a on the remote control unit, STANDBY/ON and a on the flat
screen TV.
• To cancel the Video Pattern screen, press a on the remote
control unit, press STANDBY/ON or turn a off on the flat
screen TV.
• The Video Pattern timer has priority over the sleep timer. When
the Video Pattern timer is on, the sleep timer becomes
ineffective.
Screen Protection
This function establishes multiple settings for a longer display life.
To select this option, follow the procedure below.
1 Press HOME MENU.
2 Select “Option” ( /then ENTER).
3 Select “Screen Protection” ( /then ENTER).
The following settings are automatically entered:
• Auto Size: Wide-Zoom
• Side Mask - Detection: On
• Orbiter: Mode 1
• Energy Save: Mode 1
• AV Selection: OPTIMUM (when “DYNAMIC” is selected for “AV
Selection”)
4 Select “Yes” or “No” ( / then ENTER).
5 Press HOME MENU to exit the menu.
Sleep Timer
When the selected time elapses, the Sleep Timer automatically
places the system into the standby mode.
1 Press HOME MENU.
2 Select “Sleep Timer” ( / then ENTER).
3 Select the desired time ( / then ENTER).
Select “Off” (cancel), “30 min”, “60 min”, “90 min” or “120 min”.
4 Press HOME MENU to exit the menu.
Note
• Five minutes before the selected time elapses, the remaining
time appears every minute.
• When the sleep timer has been set, “Remain ---min” appears at
the top of the menu.
Using a password
The flat screen TV provides the Channel Lock function for preventing
children from watching inappropriate programmes. You need to
enter a password when watching programmes with “Block”
specified. Before the system is shipped, “1234” is preset as the
factory-default password. You can however, change the password
as you want.
You will need to enter the password before using the “Auto
Installation”, “Analogue TV Setup” or “Password” functions from
the HOME MENU. This is to prevent unauthorized changes to the
settings.
Entering a password
You will need to enter the password after selecting a channel
blocked with the Channel Lock function, and before you can use
some of the menu functions.
• Enter your four-digit password using buttons 0 to 9.
Note
• If you fail to enter the correct password three times, “Invalid
password.” appears, and the menu is closed. In order to display
the password entry screen again to unlock the password, select
the blocked channel or open the menu again.
• If the password entry screen disappears before entry, you may
recall it by pressing ENTER.
Please Input Your Password.
PDP-LX6090.book Page 56 Monday, February 25, 2008 10:08 AM